MATERIALS / DLP
Flexible 50A
Flexible DLP resin
← Back to material selection
MATERIAL OVERVIEW
Properties to guide your selection.
A soft, translucent photopolymer with a listed Shore A hardness of 50. It can be considered for prototypes intended to simulate softer rubber or silicone-like components.
Selection considerations
Simulation behaviour is not equivalent to the final moulded material.
Discuss this material →| Printing process | DLP |
|---|---|
| Supplier-listed dimensional accuracy | ±0.05mm |
| Listed colours | Translucent |
| Tensile strength | 3.4MPa |
| Tensile modulus | Not specified |
| Elongation at break | 160% |
| Flexural strength | Not specified |
| Flexural modulus | Not specified |
| Heat deflection temperature | Not specified |
Heat deflection temperature is a test result, not a continuous-use temperature. Dimensional requirements are reviewed against the drawing.
